10-31-2021, 02:31 PM
(This post was last modified: 10-31-2021, 02:57 PM by Jesse Johannesen.)
I'll take a look and see if I can figure that out. Hold tight!
Jesse
I'm looking at this and I'm not 100% sure that there is a way to do this implemented at this point. If I try to scroll to a destination past the last PC port it just loops back to the beginning. When Steve's back I can ask him, but it may be that he just chose to not have that option because the label data isn't passed via the connection and labeling it could create a situation where the label data is inaccurate between setups. I'll report back if I get anything useful.
Jesse
Jesse
I'm looking at this and I'm not 100% sure that there is a way to do this implemented at this point. If I try to scroll to a destination past the last PC port it just loops back to the beginning. When Steve's back I can ask him, but it may be that he just chose to not have that option because the label data isn't passed via the connection and labeling it could create a situation where the label data is inaccurate between setups. I'll report back if I get anything useful.
Jesse