10-28-2021, 03:59 PM
How do I assign a label to a remote port? I have the remote 7 box and I can setup routings. Each routing has a port name like r2 but the label is none. I can’t figure out how to set this label.
Remote port labels
|
10-28-2021, 03:59 PM
How do I assign a label to a remote port? I have the remote 7 box and I can setup routings. Each routing has a port name like r2 but the label is none. I can’t figure out how to set this label.
10-31-2021, 02:31 PM
(This post was last modified: 10-31-2021, 02:57 PM by Jesse Johannesen.)
I'll take a look and see if I can figure that out. Hold tight!
Jesse I'm looking at this and I'm not 100% sure that there is a way to do this implemented at this point. If I try to scroll to a destination past the last PC port it just loops back to the beginning. When Steve's back I can ask him, but it may be that he just chose to not have that option because the label data isn't passed via the connection and labeling it could create a situation where the label data is inaccurate between setups. I'll report back if I get anything useful. Jesse
10-31-2021, 05:04 PM
The mrcc never leaves my studio and the cabling doesn’t change much. Almost 1/3 of my synths are connected to the remote box and these cannot be labeled. This seems like an unexpected user experience.
11-11-2021, 02:45 PM
FWIW, this is important to me too. I also very rarely change cabling so would be very nice to label remote ports.
11-27-2021, 01:07 PM
Yes, this is quite a frustrating limitation. Are there plans to fix?
12-26-2021, 11:20 PM
I would also love to see labeling for devices connected via the Remote7.
12-27-2021, 04:15 AM
+1 for me too
12-27-2021, 06:34 PM
Our team is taking a look to see how difficult this would be to implement, we appreciate the feedback and will let you know if we make any progress in this direction.
09-01-2022, 04:17 AM
any news about this? my remote is hidden behind a desk, so its always a bit awkward to have to look which cable goes where. now i put a sticky note next to the mrcc, but it would be great to have this inside the box.
09-03-2022, 06:49 PM
No, I haven't seen anything from Steve on this yet. I will post here if he makes any progress.
|
« Next Oldest | Next Newest »
|
Users browsing this thread: |
2 Guest(s) |