I've got a pair of these which I bought to improve my routing setup, love the feature set.. but oh boy I think I've run into a big problem. I've opened the side panel to confirm that the SD card is installed, but saving just doesn't work.
To save, this is what I do:
- Make some changes
- Navigate to tools -> load/save
-> tab stop down to the preset selection, choose User 1 (or A1, tried a few)
-> tab stop to the Save button
-> press Shift+click the encoder
A number of the out port lights will light red, but there is no indicator on the OLED, and the preset name remains red.
.. obviously this is a huge bummer, hoping there is some simple or obvious step I've missed??
To save, this is what I do:
- Make some changes
- Navigate to tools -> load/save
-> tab stop down to the preset selection, choose User 1 (or A1, tried a few)
-> tab stop to the Save button
-> press Shift+click the encoder
A number of the out port lights will light red, but there is no indicator on the OLED, and the preset name remains red.
.. obviously this is a huge bummer, hoping there is some simple or obvious step I've missed??