PC getting filtered even when no filters are on

[oldgearguy]

Steve says "doh!", took him 3 minutes to fix it. Please give it a try and reply back to this thread if it has helped.

BUG FIX:
Program Change messages fail to route when on same port as MRCC MIDI Cntrl, despite being on a different channel.

https://conductivelabs.com/forum/showthr...91#pid4391

great news.  Any info on the issue where the MRCC accepted a PC request and stored the port as part of the configuration instead of ignoring it?
Could be something wasn't initialized in the default configuration?

Can you say some more about this one? I don't quite understand the issue. Jesse probably has it documented though, I'll check with him too. The MIDI Cntrl parameters are saved globally in the eprom, so shouldn't be effected by a patch change.

Are the MIDI Cntrl parameters configured or "off"?
If configured, are you sending a PC to the MIDI Cntrl port?
If MIDI Cntrl is off, what is happening when you send a PC?

So many questions.   lol

I had set up a User 1 preset and save dit.  Never messed with the Settings pages for the MRCC itself.
So whatever the PC port and channel are out of the box/fresh OS update, that's what they were.  (Maybe a default, maybe not set internally?  no idea at this point)

When I sent a Program change message through the MRCC (sending on port 5, destination was port 4), it somehow intercepted it and set the MRCC PC port to the port I used (5).  It did not change the channel.  I never physically scrolled to the Settings menu and set the PC port.

I have not looked at my second MRCC nor played with it the same way, so it may still be in a virgin state and if so, I'll try to get the situation to reoccur and document what all happened.