04-03-2019, 02:05 PM
If you are using a USB cable to connect to Ableton, then you need to assign USB to each part, like this for example:
Pad ch4 USB4
Drone ch 3 USB3
Motif1 ch 1 USB1
Motif2 ch 2 USB2
Abelton can see the ports, but you have not assigned them to parts inside NDLR
Dont know about Ableton, but all DAW's have the ability to be Master or Slave for their transport
Pad ch4 USB4
Drone ch 3 USB3
Motif1 ch 1 USB1
Motif2 ch 2 USB2
Abelton can see the ports, but you have not assigned them to parts inside NDLR
Dont know about Ableton, but all DAW's have the ability to be Master or Slave for their transport