05-20-2025, 02:35 PM
Hi guys,
I bought an MCRR a few days ago and I’m trying to set it up in my studio.
The first issue I’ve encountered is how to monitor what’s happening on an output port. I see that I can monitor incoming messages on the input port via the routing menu, but I have no way to tell if a filtered clock is actually being filtered on a specific output port.
The MIDI monitor section is too small to effectively check what’s going on, especially if you’re dealing with a large number of messages.
I’m also wondering if there’s a way to monitor this on a bigger screen, but so far I haven’t been able to figure it out. The only solution I found is to connect a MIDI cable from the output port to a computer and check the stream with software.
Any advice?
I bought an MCRR a few days ago and I’m trying to set it up in my studio.
The first issue I’ve encountered is how to monitor what’s happening on an output port. I see that I can monitor incoming messages on the input port via the routing menu, but I have no way to tell if a filtered clock is actually being filtered on a specific output port.
The MIDI monitor section is too small to effectively check what’s going on, especially if you’re dealing with a large number of messages.
I’m also wondering if there’s a way to monitor this on a bigger screen, but so far I haven’t been able to figure it out. The only solution I found is to connect a MIDI cable from the output port to a computer and check the stream with software.
Any advice?