This function should make it possible to switch any out port(s) into a THRU state, where instead of data merged from it's routed inputs, the port processing would be overridden to output the same data as the single selected "THRU-SRC" port, which could be either any input or any other output port.
There would not be any additional routing and merging on these THRU ports as long as they remain set to the THRU mode, even though the pre-existing routing will remain in place and new routing could be added. These will however not be active as long as THRU override is enabled.
This way, we could set all the routing, remapping etc only once at the primary output and then have MRCC automatically replicate the output of the selected primary output to the THRU out(s), while possibly taking less resources than a bunch of separate duplicate routing would take. This is basically substituting a MIDI THRU boxed connected after the primary output.
Or we could do ad-hoc overrides of existing routings for simple passthrough of single input/output. For example to "mute" all the sequencing into a single output and instead temporarily play it manually from the master keyboard.
The switching and sourcing of the THRU mode would be done on a new OUTS THRU / THRU SRC screen, where yellow LED would indicate a THRU enabled port. Enabling the THRU port would be done simply by pressing and holding the desired THRU output and then pressing the single output/input to pass through that output.
There would not be any additional routing and merging on these THRU ports as long as they remain set to the THRU mode, even though the pre-existing routing will remain in place and new routing could be added. These will however not be active as long as THRU override is enabled.
This way, we could set all the routing, remapping etc only once at the primary output and then have MRCC automatically replicate the output of the selected primary output to the THRU out(s), while possibly taking less resources than a bunch of separate duplicate routing would take. This is basically substituting a MIDI THRU boxed connected after the primary output.
Or we could do ad-hoc overrides of existing routings for simple passthrough of single input/output. For example to "mute" all the sequencing into a single output and instead temporarily play it manually from the master keyboard.
The switching and sourcing of the THRU mode would be done on a new OUTS THRU / THRU SRC screen, where yellow LED would indicate a THRU enabled port. Enabling the THRU port would be done simply by pressing and holding the desired THRU output and then pressing the single output/input to pass through that output.