01-07-2023, 05:16 AM
Thank you the CP-1 modifier helps 
.
Hope Conductivelabs will update the manual.
So here is how it works:
On Routing Page
2-7
Modifier use in first slot „C-P1“(only one MIDI-Channel is sent to Port 7)
Modifier use in second „Ch1“(for MIDI Channel change)
On CHAN MAP Page
1 Ch In:1 Out:11
In this case Input Port 2 with MIDI Channel 7
is routet to Output Port 11.
But i didn’t know how to Change incoming MIDI-Channel 7. I think it is always the Same as the MIDI-Port Out.
For me that will works, but it could be easier.
Maybe someone needed this for new ideas.
.Hope Conductivelabs will update the manual
.So here is how it works:
On Routing Page
2-7
Modifier use in first slot „C-P1“(only one MIDI-Channel is sent to Port 7)
Modifier use in second „Ch1“(for MIDI Channel change)
On CHAN MAP Page
1 Ch In:1 Out:11
In this case Input Port 2 with MIDI Channel 7
is routet to Output Port 11.
But i didn’t know how to Change incoming MIDI-Channel 7. I think it is always the Same as the MIDI-Port Out.
For me that will works, but it could be easier.
Maybe someone needed this for new ideas.