08-11-2021, 06:24 PM
(This post was last modified: 08-11-2021, 06:25 PM by Jesse Johannesen.)
Ok, I'm having a lot of trouble following this issue, but I would love to help figure out how to get you where you want to be.
It sounds like what you want is to send MIDI in from the NDLR on USB Host port of your choice, then route that MIDI to either a MIDI device on a DIN Output port, OR out the PC Port to your DAW. Is that accurate?
Do you A) want these both to happen at the same time, (send to both ports at once),
B) want two separate presets for either scenario that you can load when you want to use that particular approach,
OR C) want it to always go from the NDLR into the MRCC and out to the DAW, then back into the MRCC and back out to the DIN port Synth afterwards?
These should all be possiblilities.
Jesse
It sounds like what you want is to send MIDI in from the NDLR on USB Host port of your choice, then route that MIDI to either a MIDI device on a DIN Output port, OR out the PC Port to your DAW. Is that accurate?
Do you A) want these both to happen at the same time, (send to both ports at once),
B) want two separate presets for either scenario that you can load when you want to use that particular approach,
OR C) want it to always go from the NDLR into the MRCC and out to the DAW, then back into the MRCC and back out to the DIN port Synth afterwards?
These should all be possiblilities.
Jesse