05-15-2025, 02:08 PM
Hello MRCC Support,
I was reading through this problem, and my new MRCC which I just hooked up today seems to be experiencing the "freeze" problem.
I updated the firmware from 1.1.071 to 1.1.075, but the MRCC will still "freeze" and become unresponsive after a while of switching around inputs/outputs.
The only way I have found to unfreeze the unit, is to power it off and on again, and then it is ok for a while before it freezes again.
Have you seen this behavior before, and/or is it related to what people are talking about on this thread?
Please advise.
Thank You!
I was reading through this problem, and my new MRCC which I just hooked up today seems to be experiencing the "freeze" problem.
I updated the firmware from 1.1.071 to 1.1.075, but the MRCC will still "freeze" and become unresponsive after a while of switching around inputs/outputs.
The only way I have found to unfreeze the unit, is to power it off and on again, and then it is ok for a while before it freezes again.
Have you seen this behavior before, and/or is it related to what people are talking about on this thread?
Please advise.
Thank You!