Use with Studio One

[TBrett]

---

Hi Jesse. I was using some software editors yersterday and thought I would give some feedback. I found that I could send midi out to a module but not back to the pc. For instance, using Edisyn for my E-Mu P2500, I could sned a test tone, and change presets, but I couldn't download the iibrary from the P2500. Both were on PC port 4 in and out, sys ex id correct.  Same for my JV 2080, could change patcges and play notes, but couldn't get info back. Also I noticed I couldn't run an editor and use Studio one at the same time, do I need to use a seperate port for editors so I can? I also change my config on the mrcc and just dedicated 1 port for each synth, but I notice some difference in the port numbering. For instance. My deepmind 6 is set to port 6 in and out on the mrcc, but Studio one I had to set it port 7. Some were different, some, like the E-Mu were the same, port 4.The JV 2080 same, port 5. all the others were different.  Through trial and error I set it all up and it's functional, and not sure if it's operator error, but though you might like the feed back. I installed the beta hex 1.1.089. Cheers.