04-11-2025, 02:53 PM
(04-11-2025, 01:02 PM)Jesse Johannesen Wrote: If I remember correctly, we had been doing something which was problematic with the way things enumerated a while back which mostly caused problems with Apple, but mainly when using 2 devices. Are you on the latest beta firmware? As you may have seen we recently took a good deep look at our USB enumeration and port naming and I think we're pretty confident that naming issues are fixed on our end. It's always possible that I'm wrong, but I don't think there is anything we're doing that would prevent the ports from showing up in normal (correctly implemented) use cases. You my reach out to the Studio one devs and ask them to get in touch with us (support@conductivelabs.com) and we can see if there's anything we can do to steer them in the right direction.
Thanks for the reply. I slept on it and realized my mistake. I was confusing the ports listed on studio one between the PC ports and the din/usb inputs ( it had been a long day). Woke up and it was clear what I had been thinking. MRCC is port 1, and then MRCC2 is port 2 etc. Set it all up on the MRCC and is working now, although when I put my 4 mono-timbre synths all on port 1 (even with different midi channel assignments) Studio One warned of conflicts. Are the PC ports on the MRCC supposed to be for one unit or is it fine to run multiples on 1 port? Even though it all set up in S1 with labels now, I will look at the beta FW, I normally avoid betas, but I will check it out.