MRCC Firmware Release 1.1.095

[Jesse Johannesen]

(03-01-2025, 02:24 PM)ekkomouse Wrote:
Separately I have an issue where I have a routing where clock is going from MRCC one to two, MRCC 2 Is sending clock back to a remote routing on 12 unintentionally when it’s not assigned , The only way I can stop it is to filter on the outport page.
https://www.dropbox.com/scl/fi/nv8podofy...ksdrs&dl=0

OK so for this one, the video doesn't show the MRCC doing anything funky. I recreated the issue by sending MRCC internal clock on PC port  1 of unit 1 to the USB host C port of unit 2 Factory restting unit 2, I still see Red Clock Arrows on the display. I think this is the expected behavior, as I get the same results from sending via DIN as well. 

Not to say the issue you're reporting doesn't exist, but what is shown in the video doesn't illustrate an issue as far as I can tell. 

If you were to factory reset the MRCC that is the clock source and it still showed red arrows on the destination then we would be looking at an issue, but here you are factory resetting the destination unless I am misunderstanding?

---

My SL has two outputs, they are simply wired into DIN INPUT 1 & INPUT 2 and then straightforwardly routed into 1 to 4 outputs each,  both DIN & USB.

Oxi is routed in the same manner, but has 3 OUTs, that go through expander DINs that is connected to USB1. This is a workaround, because the direct OXI-MRCC USB connection can currently handle only 2 rather then 3 outs.

The outputs of the SL / OXI are "synth groups" - out 1 = monos, out 2 = polys, out 3 for add-hoc routing into drum machine / grooveboxes.

Outs from MRCC are similar, but sub-groups in nature - i.e. OUT1 monos on the left side, OUT 2 monos at the right side, same with 3 and 4 for polys, 5 is digitakt, etc.

Got it. A couple things we can do to pin down the issue:

1 we can try and capture the output of the SL3 in MIDI Ox to see what data is being sent when that hold button is pressed
2 we can try to replicated the issue with simplified setup by loading a factory preset and attempting to send only those notes to a single destination and see if it is reproducable. 

for the OXI can we try it without the Xpander and see if the problem persists with a direct connection?