MRCC Firmware Release 1.1.095

[Jesse Johannesen]

on the in port filter page, by default you get one to 6, A, B, C 1-4 and D1-2, missing is D3-4, P1-12. 

on the outport filter page you get 1-12, A-D, P1-4, Missing P5 to 12. 

Separately I have an issue where I have a routing where clock is going from MRCC one to two, MRCC 2 Is sending clock back to a remote routing on 12 unintentionally when it’s not assigned , The only way I can stop it is to filter on the outport page. 

https://www.dropbox.com/scl/fi/nv8podofy...ksdrs&dl=0

So I was trying to reproduce the issue in the video by sending the MRCC clock out of PC port 1 on MRCC1 to the C port of MRCC2, Factory reset MRCC 2 and it still shows clock (red arrow on input) which matches the video, however that is the expected behavior. If I send Clock to a DIN port it also shows red Clock arrows at that ports input. I thought initially that it was only showing what is actually routed, but I tested it with notes as well and was it also shows that data on the inputs as green arrows regardless of any existing, or non existing routings.

I still want to get to the bottom of the phantom loop back issue, but can you help me understand if this specific report can be closed or if I need to try something else to reproduce what you're reporting (did I understand the assignment in other words).


Thanks again for reporting.