03-13-2025, 02:54 AM
(This post was last modified: 03-13-2025, 02:56 AM by RadekPilich.)
My SL has two outputs, they are simply wired into DIN INPUT 1 & INPUT 2 and then straightforwardly routed into 1 to 4 outputs each, both DIN & USB.
Oxi is routed in the same manner, but has 3 OUTs, that go through expander DINs that is connected to USB1. This is a workaround, because the direct OXI-MRCC USB connection can currently handle only 2 rather then 3 outs.
The outputs of the SL / OXI are "synth groups" - out 1 = monos, out 2 = polys, out 3 for add-hoc routing into drum machine / grooveboxes.
Outs from MRCC are similar, but sub-groups in nature - i.e. OUT1 monos on the left side, OUT 2 monos at the right side, same with 3 and 4 for polys, 5 is digitakt, etc.
Oxi is routed in the same manner, but has 3 OUTs, that go through expander DINs that is connected to USB1. This is a workaround, because the direct OXI-MRCC USB connection can currently handle only 2 rather then 3 outs.
The outputs of the SL / OXI are "synth groups" - out 1 = monos, out 2 = polys, out 3 for add-hoc routing into drum machine / grooveboxes.
Outs from MRCC are similar, but sub-groups in nature - i.e. OUT1 monos on the left side, OUT 2 monos at the right side, same with 3 and 4 for polys, 5 is digitakt, etc.