MRCC Firmware Release 1.1.095

[ekkomouse]

@ekkomouse
The port filter page allows you to select an input port per line, with the first column allowing you to select an input port. For convenience, each line defaults to a port listed in numerical order, however this was primarily to make it simpler to understand than leaving the port selection blank and forcing you to adjust it manually. You can simply go to the first port line that is not in use, and in the port column, use the encoder to select the port you wish to add a filter on, then if you need another you can go to the next line and do so again. 

As for older presets, I think we expected them to still work going back several FW versions. If you want to you can send me an email with the details and we can take a look at that. I don't know what might be possible as far as fixing the issue yet, but I'm happy to take a look.

As for the clock issue in the video that is interesting, I should be able to repro that here and see if we can get it fixed next time we're looking at the code.
A

Yeah I’m familiar with being able to change which port is getting filtered, which brings up the issue when you are filtering one and then want to filter a different one on try he same preset, Since they’re not all represented, it’s an extra workflow which just seems like they should all be represented. Also, it would cut down on potential loops, as you Could definitively filter each input and output. 

my report on the preset is not really about saving the preset. It’s more about the issue of midi clock passing through when a routing hasn’t been created