NDLR via MRCC no activity when using USB
Hello,
I received my NDLR today, successfully updated the firmware and I'm trying to use MRCC's USB Port A (using the cable which I received with NDLR) to send NDLR's MIDI out to my synths. All synths are connected via DIN,
No computer involved.
For testing, I've set NDLR's MIDI config to 4 all, 1 all, 2 all, 3 all. MRCC shows no activity at all on any virtual cable in Port A (the same when I try port B.
For testing, too, I've set my synths to omni mode.
When using DIN, there is no problem, but I try to save MRCC's precious last two free DIN in ports for other controllers, and the USB option between MRCC and NDLR looks much more elegant to me.
What did I overlook?
P.S:The blue LED over MRCC's device port is always on, no cable connected. Is this normal?
I received my NDLR today, successfully updated the firmware and I'm trying to use MRCC's USB Port A (using the cable which I received with NDLR) to send NDLR's MIDI out to my synths. All synths are connected via DIN,
No computer involved.
For testing, I've set NDLR's MIDI config to 4 all, 1 all, 2 all, 3 all. MRCC shows no activity at all on any virtual cable in Port A (the same when I try port B.
For testing, too, I've set my synths to omni mode.
When using DIN, there is no problem, but I try to save MRCC's precious last two free DIN in ports for other controllers, and the USB option between MRCC and NDLR looks much more elegant to me.
What did I overlook?
P.S:The blue LED over MRCC's device port is always on, no cable connected. Is this normal?