08-07-2022, 01:58 PM
(This post was last modified: 08-07-2022, 02:04 PM by nexgenmusic.)
Hello,
I have a question regarding if it is possible to route hardware synth midi (via 5pin) to the PC/DAW from a 2nd MRCC (as follower) over to a 1st MRCC (as leader connected directly to the PC)? Both MRCCs are connected bi-directionally via the ethernet. I have prepared a quick diagram to explain such a scenario. I would rather not have to plug the 2nd MRCC into the PC if I don't have too.
Cheers,
Dan
I have a question regarding if it is possible to route hardware synth midi (via 5pin) to the PC/DAW from a 2nd MRCC (as follower) over to a 1st MRCC (as leader connected directly to the PC)? Both MRCCs are connected bi-directionally via the ethernet. I have prepared a quick diagram to explain such a scenario. I would rather not have to plug the 2nd MRCC into the PC if I don't have too.
Cheers,
Dan