MRCC USB Host update

[Jesse Johannesen]

Updated both units - Tested Toriaz Squid, connecting the USB D works, but as soon as you select it's IN, the MRCC freezes and needs to reboot.
I actually don't mind a freeze opposed to just not working when it opens up more units. Moog One is next.

Hey Raphie, can you please explain what you mean by: "Freeze" vs. not working when it opens more units? what is the unit you are referring to here? 

Also as far as I know the Moog One has been reported as not working, did you have any luck getting it to enumerate?

Jesse

---

Updated both units - Tested Toriaz Squid, connecting the USB D works, but as soon as you select it's IN, the MRCC freezes and needs to reboot.
I actually don't mind a freeze opposed to just not working when it opens up more units. Moog One is next.

I believe I'm seeing the same. Trying to send sync from the computer to the USB connected OXI, as soon as I hit the In button for the OXI the MRCC freezes.

Often freezes are the result of a MIDI loop. If you are sending clock, be extra sure to check that the signal is not being fed back anywhere downstream. Not sure that this is the issue, since obviously this device has had a contentious relationship with the MRCC USB ports already and I'm sure we weren't able to test it in every possible scenario while we were getting it to work.

A good way to test if it's a MIDI loop is to pull the Clock source out of the MRCC port and see if it stops being totally locked up. If it was a MIDI loop then it will often "un-lockup".