11-29-2021, 07:21 PM
So I asked Steve about this and he said he would do some testing today, but the behavior should match the Manual. I did some tests as well and couldn't get a DX7 patch to pass, but after looking at the manual it looks like the largest sysex buffer that can be sent is 256 bytes, so the 5k DX7 patches not working is expected behavior. If I go into the setup I can configure it to send 256 byte segments though, and it will pass. Steve was able to confirm after testing today that the only ports that do not pass sysex are ports 7-12, which is a known issue. All other ports will pass so long as the "chunks" are less than 256 bytes.
This doesn't sound like it solves the mystery if you're getting 16K files out of it already it sounds like it must already be an acceptable buffer size or no data would pass I'm guessing. Can you compare the data and see if it's just the first 16k of the sent file?
Jesse
This doesn't sound like it solves the mystery if you're getting 16K files out of it already it sounds like it must already be an acceptable buffer size or no data would pass I'm guessing. Can you compare the data and see if it's just the first 16k of the sent file?
Jesse