08-27-2021, 01:59 AM
Thanks all for your answers.
@Jesse: my issue is with the USB ports. I don't think they have the same limitation as the DIN 7-12 ports.
I made some progress! My preset was corrupt. I don't know when and how. But this morning it would not load (see my post about that) and so I did a factory reset on my MRCC.
I'm testing each of my devices individually. Only the device under test is connected to the MRCC. So far, it's better. I can send/receive sysex messages with My Hydrasynth and my Netktar Pacer. I can even use the Hydrasynth Manager without any problem.
I will now begin to connect more than one device on the MRCC. I'm crossing fingers.
I'll keep updating this thread with my test results...
@Jesse: my issue is with the USB ports. I don't think they have the same limitation as the DIN 7-12 ports.
I made some progress! My preset was corrupt. I don't know when and how. But this morning it would not load (see my post about that) and so I did a factory reset on my MRCC.
I'm testing each of my devices individually. Only the device under test is connected to the MRCC. So far, it's better. I can send/receive sysex messages with My Hydrasynth and my Netktar Pacer. I can even use the Hydrasynth Manager without any problem.
I will now begin to connect more than one device on the MRCC. I'm crossing fingers.
I'll keep updating this thread with my test results...