Hi - I've re-arranged all my MIDI gear and Pro Tools DAW so that everything is routed via the MRCC. It's a fantastic device! Everything is now instantly available, such that, for the moment, I'm not even bothering to save presets - it's so easy to route paths of MIDI data.
However, I have a problem with Sysex messages not being transmitted from MRCC input to output.
I have a Roland JX-8P synth and I use an iPad app (IPG-800) to edit patches. Routing via a single MIDI cable from the iPad (which is mounted in a Focusrite iTrack Dock MIDI interface) to the synth works fine, as usual.
However, if I patch the iTrack Dock to the JX-8P using the MRCC, the Sysex messages don't get through. All MIDI note data is transmitted OK.
Thanks, Mick
I've just been searching back through the messages on the forum, and I found a message about Sysex data posted by Jesse on 4-25-21:
"I am not sure about the length of the messages, but I think the philosophy as far as I've seen has been to pass everything. The exception is that the DIN ports above 6 use a hand written code to send MIDI data, and SYSEX hasn't yet been implemented on that protocol yet. I will report back once I know more."
I've been trying to send data out on Remote7, output 1. Having re-patched my MRCC MIDI setup to send the data out on main output 6, the Sysex data is successfully transmitted to my JX-8P.
Has there been any development in the coding? It would be convenient to be able to send Sysex on any output if possible, please.
However, I have a problem with Sysex messages not being transmitted from MRCC input to output.
I have a Roland JX-8P synth and I use an iPad app (IPG-800) to edit patches. Routing via a single MIDI cable from the iPad (which is mounted in a Focusrite iTrack Dock MIDI interface) to the synth works fine, as usual.
However, if I patch the iTrack Dock to the JX-8P using the MRCC, the Sysex messages don't get through. All MIDI note data is transmitted OK.
Thanks, Mick
I've just been searching back through the messages on the forum, and I found a message about Sysex data posted by Jesse on 4-25-21:
"I am not sure about the length of the messages, but I think the philosophy as far as I've seen has been to pass everything. The exception is that the DIN ports above 6 use a hand written code to send MIDI data, and SYSEX hasn't yet been implemented on that protocol yet. I will report back once I know more."
I've been trying to send data out on Remote7, output 1. Having re-patched my MRCC MIDI setup to send the data out on main output 6, the Sysex data is successfully transmitted to my JX-8P.
Has there been any development in the coding? It would be convenient to be able to send Sysex on any output if possible, please.