Conductive Labs Support Forum › MRCC - MIDI Router Control Center › General Support v
PC from Digitakt Not Sending

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
PC from Digitakt Not Sending
mbl77 Offline
Junior Noodler
**
Posts: 4
Threads: 1
Joined: Mar 2021
Reputation: 2
0
#6
08-04-2021, 01:28 AM (This post was last modified: 08-04-2021, 02:24 AM by mbl77.)
I'm having the same issue with my MPC. Program change is sent just fine through my Midiface 8x8, but is not sent with the MRCC. I do see green activity lights on the MRCC, but the synth doesn't receive anything. I have no filters set up. I also just upgraded to 1.1.025, without any change.
Additional info... From the routing screen I am seeing the PC messages, however if I go to the MIDI monitor page, I don't see any PC messages.
Find
Reply


Messages In This Thread
PC from Digitakt Not Sending - by asantarosa - 07-26-2021, 09:06 AM
RE: PC from Digitakt Not Sending - by Darryl - 07-27-2021, 04:21 PM
RE: PC from Digitakt Not Sending - by asantarosa - 08-03-2021, 11:33 AM
RE: PC from Digitakt Not Sending - by Darryl - 08-03-2021, 02:57 PM
RE: PC from Digitakt Not Sending - by asantarosa - 08-04-2021, 10:30 AM
RE: PC from Digitakt Not Sending - by mbl77 - 08-04-2021, 01:28 AM
RE: PC from Digitakt Not Sending - by mbl77 - 08-04-2021, 10:51 PM

Forum Jump:


Users browsing this thread:
1 Guest(s)