08-03-2021, 08:12 AM
(08-03-2021, 07:50 AM)oldgearguy Wrote: What happens if you run the ERM directly into the MRCC? Does it get distributed properly? You have to explicitly map whatever input has the clock signal to all the outputs that need it.
The reason for asking is that I have a KeyStep and Multiclock and it's been working fine.
However, I have the ERM and keyStep on separate ports on the MRCC rather than chain ERM to KeyStep to MRCC.
For me, it made more sense since I can then use just the start/stop on the ERM to drive everything (including the KeyStep arpeggiator).
It also means I'm not sending MIDI note info to a bunch of gear (like a delay module) that doesn't need to see it.
Thank you for the quick reply. If I run the ERM direct into any midi in, select an output (lit blue) to the synth then there is no sync. Is this what you mean by the mapping? Navigating the menus so far has me a little confused right now as I only got this earlier today.