08-03-2021, 02:18 AM
(08-02-2021, 06:42 PM)Nelson Baboon Wrote: sigh. here i am again, struggling to do something simple, but getting confused by the manual.
I just received mine a few days ago, direct from you - the firmware is 1.0.147. The manual says that as of 1.1.020, there should be a choice of 2 modes - copy 1-5 or remote 1-5. I see no evidence of that in the settings 2 menu, where this choice is supposed to be. the following is a bit confusing - we are already in the settings 2 menu, but then it says, "these are also found in the setting menu #2. ???
Your MRCC is on a slightly older firmware version, so upgrading may help match up the screens/steps with the manual.
Note that as part of the beta testing process, the manual was reviewed and changed a lot over the course of time. All of us fall prey to the "I already know that" situation when reviewing the steps in the documentation versus what is on the screen. One of the challenges is spending enough time on the documentation late in the process to make sure the steps as documented match the firmware as closely as possible knowing that future sw releases might cause disconnects.
What would be helpful to future owners is if folks like you (and others that have made comments about the docs) sent specific change requests to Jesse directly via PM so that an updated manual might clarify the currently cloudy areas for others.
(sorry for volunteering you Jesse - well not really)