Conductive Labs Support Forum › MRCC - MIDI Router Control Center › General Support v
PC from Digitakt Not Sending

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
PC from Digitakt Not Sending
Darryl Offline
Super Moderator
******
Posts: 701
Threads: 43
Joined: Aug 2018
Reputation: 69
1
#3
07-27-2021, 04:21 PM
I just retested sending Program Change and it works. I tested routing from the PC and from MRCC Input 1 to Output 1.

Definitely do a firmware update if you don't have 1.1.025 already. Its on our Download page

Assuming the Digitakt is on a 5 pin DIN Input. Are all of your synths on 5 pin DIN outputs?

Do you have any MODs or filters setup on MRCC?
Find
Reply


Messages In This Thread
PC from Digitakt Not Sending - by asantarosa - 07-26-2021, 09:06 AM
RE: PC from Digitakt Not Sending - by Darryl - 07-27-2021, 04:21 PM
RE: PC from Digitakt Not Sending - by asantarosa - 08-03-2021, 11:33 AM
RE: PC from Digitakt Not Sending - by Darryl - 08-03-2021, 02:57 PM
RE: PC from Digitakt Not Sending - by asantarosa - 08-04-2021, 10:30 AM
RE: PC from Digitakt Not Sending - by mbl77 - 08-04-2021, 01:28 AM
RE: PC from Digitakt Not Sending - by mbl77 - 08-04-2021, 10:51 PM

Forum Jump:


Users browsing this thread:
1 Guest(s)