05-05-2021, 09:56 AM
I had originally misinterpreted your post as saying you had not found where in the manual this is discussed, but noticed shortly after posting my reply, sorry for the confusion. I think what needs to be done to solve this may be to use 2 different ports. Since your MIDI is going out USB1 to your DAW, can you send it back through USB 2? that way it isn't then sent back into the DAW for a second pass, and goes out to downstream MIDI gear from there? USB 2 has the added bonus of passing start and stop messages to downstream gear, which may be beneficial (or not, depending on your setup).
USB 1 in sends MIDI data thru to 5pin DIN A and out USB1, where USB 2 sends out 5Pin DIN B, and USB2, passing (Start & Stop).
The path would look something like this:
NDLR-USB1->DAW-USB2->NDLR-5PINB->-(splitter?)->Synths
\->USB2->DAW->Synth plugins
Does that seem like it might be doable?
Jesse
USB 1 in sends MIDI data thru to 5pin DIN A and out USB1, where USB 2 sends out 5Pin DIN B, and USB2, passing (Start & Stop).
The path would look something like this:
NDLR-USB1->DAW-USB2->NDLR-5PINB->-(splitter?)->Synths
\->USB2->DAW->Synth plugins
Does that seem like it might be doable?
Jesse