(03-10-2019, 10:36 PM)Darryl Wrote: The NDLR doesn't use Start when using an external clock. It starts when the clock starts. It should start all parts that are armed. See the manual (version 1.3) page 32 (section titled "External MIDI Clock & Stop/Start/Continue Messages").
NDLR Cntl and KB Trans must be on separate ports.
1.3 manual: "MIDI 5 Pin port B & USB port 1 - MIDI Stop/Start/Continue messages are ACCEPTED"
Bitwig triggers nothing unless Start/Stop is enabled. Nice to note that hitting Start repeatably, now Start/Stops the NDLR...nice
** Changing KB Trans to another port, solved the reported 'Pads not triggering when using external clock' issue...I would suspect this to be an unintended side effect of having both Cntl and KB Trans on the same ports.