How is channel routing done?

[cowboy]

Jesse, any extra info would be great, because I can't visualize what that workflow would be like. One thing I was thinking would be to give each synth its own physical output, but to set every synth to channel 1. That way, all I'd need to do would be to map a channel from the sequencer input to an output. For example, I might want:

• Sequencer input channel 1 -> output 1 (channel 1)
  
• Sequencer input channel 2 -> output 2 (channel 1)
  
• Sequencer input channel 3 -> output 3 (channel 1)
  
• Sequencer input channel 4 -> output 4 (channel 1)
  
• Sequencer input channel 5 -> output 5 (channel 1)
  
• Sequencer input channel 6 -> output 6 (channel 1)
  
• Sequencer input channel 7 -> output 7 (channel 1)
  

And then be able to change which output any of those goes to at any time, eg.

• Sequencer input channel 1 -> output 1 (channel 1)
  
• Sequencer input channel 1 -> output 2 (channel 1)
  
• Sequencer input channel 1 -> output 3 (channel 1)
  
• Sequencer input channel 4 -> output 4 (channel 1)
  
• Sequencer input channel 5 -> output 5 (channel 1)
  
• Sequencer input channel 6 -> output 7 (channel 1)
  
• Sequencer input channel 7 -> output 6 (channel 1)
  

(etc)