Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
KeyStep controlling The NDLR
#3
(12-02-2018, 02:39 AM)Alphacentaury Wrote: Thanx a lot to have thought to us with these details.

Behind the keystep, witch mode? Midi, internal, sync ,

In this setup the clock was being generated by the NDLR.  The Beatstep’s clock was being ignored.

If you route The NDLR’s clock back to the Beatstep (either The NDLR’s analog CLK OUT, or the 5 PIn MIDI out) and set the Beatstep to use external clock, the arpeggiator or sequencer from the Beatstep can also be used and routed through transpose MIDI channel. And the notes will be played in sync. 

OR 

use the Beatstep clock and set The NDLR to use external clock. The simplest connection would be to use one 5 pin MIDI cable out of the Beatstep into The NDLR. Both the note events and clock will communicated over the 5 pin cable.  The MIDI clock events are not channel specific.

BIG Note: The downside to this last method is that the Beatstep’s clock is not transmitted unless the play button is pressed. If The NDLR does not receive Clock messages none of the internal part (pad, drone or motifs) will play. This is because The NDLR uses the external Clock messages as its internal heartbeat when set to external Clock in. 

Steve
Reply


Messages In This Thread
KeyStep controlling The NDLR - by Steve - 11-27-2018, 01:36 PM
RE: KeyStep controlling The NDLR - by Steve - 12-03-2018, 07:24 AM
RE: KeyStep controlling The NDLR - by GaGa - 08-20-2020, 10:50 AM

Forum Jump:


Users browsing this thread:
1 Guest(s)