Conductive Labs Support Forum › MRCC - MIDI Router Control Center › General Support v
Timing specs/precision

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Timing specs/precision
Jesse Johannesen Offline
Moderator
*****
Posts: 1,277
Threads: 7
Joined: Jan 2020
Reputation: 65
6
#5
09-23-2020, 08:54 AM
(09-22-2020, 01:32 PM)milleborne Wrote: Could there be a function to manually adjust midi timing +/- (push or pull in milliseconds or samples) right on the MRCC, in order to compensate for latency so that overall output can all be adjusted to sync?
I'm not sure how it would be possible to push a MIDI message? It has to receive a MIDI message before it can pass it, so it seems like this would need to be handled upstream, no?
Find
Reply


Messages In This Thread
Timing specs/precision - by FlavioB - 11-30-2019, 04:08 AM
RE: Timing specs/precision - by yomanfree - 12-03-2019, 02:06 PM
RE: Timing specs/precision - by Darryl - 12-05-2019, 07:54 PM
RE: Timing specs/precision - by FlavioB - 12-02-2020, 03:33 AM
RE: Timing specs/precision - by milleborne - 09-22-2020, 01:32 PM
RE: Timing specs/precision - by Jesse Johannesen - 09-23-2020, 08:54 AM
RE: Timing specs/precision - by milleborne - 09-28-2020, 04:00 AM
RE: Timing specs/precision - by Jesse Johannesen - 12-02-2020, 08:48 AM
RE: Timing specs/precision - by FlavioB - 12-04-2020, 06:41 AM
RE: Timing specs/precision - by Jesse Johannesen - 12-04-2020, 09:15 AM
RE: Timing specs/precision - by Darryl - 12-02-2020, 04:20 PM
RE: Timing specs/precision - by Darryl - 12-02-2020, 04:26 PM
RE: Timing specs/precision - by SP-1200 - 02-05-2021, 11:36 AM
RE: Timing specs/precision - by FlavioB - 02-05-2021, 12:13 PM
RE: Timing specs/precision - by SP-1200 - 02-05-2021, 12:18 PM
RE: Timing specs/precision - by FlavioB - 02-10-2021, 05:13 AM
RE: Timing specs/precision - by oldgearguy - 02-06-2021, 04:36 AM
RE: Timing specs/precision - by Darryl - 02-07-2021, 06:14 PM
RE: Timing specs/precision - by SP-1200 - 05-02-2022, 11:09 AM

Forum Jump:


Users browsing this thread:
1 Guest(s)