Pressing the pad encoders does not bring up the pad sub screen

[Jesse Johannesen]

Thank you guys! I did some more testing today and in all scenarios the Pad sub screen behavior is the same. The pad sub screen never comes up when clicking the pad encoders. To bring the screen up the encoders have to be twisted (so you are making a change blindly before you can see the previous setting on the screen) The other parts and the tempo/key/mode sub screens always come up when clicking any of their respective encoders. If you don't click and just twist an encoder, the screen also comes up but with the corresponding value controlled by the encoder changed (as expected).
I have tried to reproduce the behavior described by Detunedoscillator above regarding Motif 1 and Motif 2 but in the testing I did in my unit they work fine. This is what I did:
1- With the four parts engaged, I click on the Motif selector, the sub screen of one of the Motifs comes up and then I can switch back and forth the Motif screens by pressing the selector button without problems.
2- I go from either Motif screen to the drone or the tempo (by clicking their respective encoders) then switch back to the Motif screen I was before by clicking on any of the Motif encoders. If I then click the Motif selector button, it switches to the other Motif screen.
Cheers
J

Jose, thank you for providing this information, I can concur that this is exactly the behavior I see as well.

Detuned, can you give this another shot and confirm that your device behaves differently? Maybe check the firmware number for me in Settings menu 3/3 (you may need to press the lower right encoder button to switch from serial number to fw number.

Thanks again to both of you,
Jesse