New(er) NDLR rotary buttons make it hard/impossible to dial in CCs

[detunedoscillator]

Hi there.
I got my NDLR the last days and am quite up to date with the usage - i heavily dived into it the last days.
Now i found a problem that is somewhat annoying.

During my reading in this forum i realized that there were different rotary controllers on the first NDLRs that went out.
I have one with the rasterized steps.

If you enter the „MIDI CNTLR“ (Button 4 In Shift + Menu mode) on pretty much any screen i can only set the values in steps of 2 - which might be unproblematic when setting volume or panning but gets difficult when setting CC values!

In the „MIDI CNTLR“ Menu rotate Button 1 to screen 4 (Pad) and try to set the bottom CC values vor CC1 and/or CC2.
Here i also get only steps of 2. From 61 -> 63 -> 65, etc...
The values in between are on the „height“ of the button rasterization (hard to name it, no native English speaker here).
If i want to set it to eg. 62 i have to half-turn the knob and hope it stays that way until i leave the screen/setting.

Hard to describe, easy to reproduce, very hard to work around or live with it if one wants to use these features.
Recommendations Jesse, Darryl?

I hope you can alter the steps finer in the code so that the new rotary controls are also able to fully customize the NDLR 
I would hate to exclude these features from my workflow.

Kind regards.

If the developers are looking for a solution, I suggest looking at the hydrasynth handles situations where you need more granular control over inputting values. To explain, what happens with that synth is if you want to put in a precise value like 30, it can be easy to shoot past it and end up with something like 31.25. To compensate for this the synth allows you to hold down the shift button while turning any encoder knob which slows the speed the knobs dial in the numbers. A similar approach could be applied to the NDLR.