Trigger Motif to play x-number of bars then stop

[endreola]

Hey endreola, glad to hear you're getting on well with the NDLR! If I'm understanding your goal correctly that should be doable in the mod matrix, motif on/off is a viable destination so you could send an lfo timed to the frequency you want to turn it on and off. I haven't tried this yet, but you might even be able to send a ramp shape and by changing the mod amount you could change the point it transitions to be earlier or later than the 50% point.

Otherwise CC87/88 is motif 1/2 play/pause and a it changes state as follows: >62 = play <63 pause, but getting things to work without a midi loop while keeping the same setup could be difficult without knowing exactly what data is causing the loop.  my advice is see if you can get the lfo to work and report back.
Good luck,
Jesse

---

Jesse,

Thank you for the guidance.  Your suggestion to use mod matrix worked like a charm.  And the midi loop issue was user error. Even though I don't use a KB to control the NDLR, I made the mistake of using the same channel...

Cheers

I'm glad to have been of service!
Happy NDLing,
Jesse

Using Mod Matrix with square wave LFO does toggle the part on/off, which was the effect that I was seeking. To my surprise after pressing off button it auto started again at the next cycle.  Made me chuckle.  It would be great if this behavior can be modified somewhat whereby pressing the on/off acts as a master override, thus preventing the part to auto restart.

By using the button combo [SHIFT+PLAY/PAUSE] you can pause modulation for any part. By substituting the PLAY ALL you can pause all parts Modulation. Give that a shot and hopefully this does what you're looking for.
Jesse

Great suggestion, Jesse.  

Toggling PAUSE does indeed achieve the effect that I'm after.  The part restarts after unpausing but I haven't yet found its sweet spot where it will restart on the 1st bar.  It tends to lag somewhat and mostly restarts on bar 2 and randomly on bar 3 or 4.  This does make for a cool effect but not for my current project.  Think I attempt automating it via Pyramid sequencer, see if that provides a more consistent result.

As always, you guys have been great supporting the community with quick responses!  

Cheers