01-14-2020, 06:53 PM
This sounds a bit like a recently reported issue that its on Steve's list of things to look at. You can see a description here: https://conductivelabs.com/forum/showthr...03#pid1603
The work around for the moment is to enter the Pattern editor, then exit it. That will set the correct position and number of position increments for the selected motif. Check it out and let us know if you think this is the same issue.
The work around for the moment is to enter the Pattern editor, then exit it. That will set the correct position and number of position increments for the selected motif. Check it out and let us know if you think this is the same issue.