Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
mrcc880 no midi f/ Keystep 37
#1
New owner of an MRCC 880 here. I'm pretty new to MIDI workflows and I can't the get the MRCC 880 to receive Midi note data from my Keystep 37. It receives and sends data from my Roli Seaboard Block M just fine, but nothing registers from the Keystep. I know the Keystep is sending midi data, as indicated both from Ableton and from Arturia's midi control center. I've double checked the 5-pin din cable and it works fine when sending midi out of the Keystep directly into my desktop Hydrasynth. However, when I try and route through the MRCC 880, I get nothing.

Can anyone shed some light on why these two devices aren't communicating?

Big thanks in advance for anyone willing to assist,

Stephen
Reply
#2
The other thread you followed mentioned that they were having issues with the Hydrasynth as well. Not sure why that would be, but I know we have one in the lab, so I can ask Darryl to set up a test.
Reply
#3
(09-17-2024, 12:50 PM)Jesse Johannesen Wrote: The other thread you followed mentioned that they were having issues with the Hydrasynth as well. Not sure why that would be, but I know we have one in the lab, so I can ask Darryl to set up a test.

Hi Jessie, Thanks for chiming in. Actually, it is not Hydrasynth issue. I've since done a little more trouble shooting and it turns out the MIDI IN 2 (on the MRCC 880) is defective. My controllers and synths work through the 5-pin ins on channels 1,3 and 4. It's just #2 that isn't transmitting any data. I'm hopeful I'll be able to get a replacement sent quickly.
Reply
#4
Got your email, we'll get you set up for a replacement. Go ahead and follow the return instructions I included and we'll get that rolling.
Cheers.
Reply


Forum Jump:


Users browsing this thread:
1 Guest(s)