Conductive Labs Support Forum
Blank spot in screen shortly after boot up - Printable Version

+- Conductive Labs Support Forum (https://conductivelabs.com/forum)
+-- Forum: The NDLR (https://conductivelabs.com/forum/forumdisplay.php?fid=1)
+--- Forum: General Support (https://conductivelabs.com/forum/forumdisplay.php?fid=2)
+--- Thread: Blank spot in screen shortly after boot up (/showthread.php?tid=972)



Blank spot in screen shortly after boot up - 190531085100 - 06-05-2020

Something curious is happening to my NDRL - https://imgur.com/a/tynckVg - the screen goes blank in the middle, about 20 seconds after boot. This started to happen 2 week ago, even though I changed nothing, no firmware update, no cable or power changes. What could be going on?

When I push a button, the screen comes back. It does not come back on push of one of the chord buttons. If I remember correctly, it happened only occasionally in the beginning, but now it's on every power cycle. Firmware is 1.1.064. Planning to upgrade soon, I'm just wondering if I should be worried about anything else.


RE: Blank spot in screen shortly after boot up - Jesse Johannesen - 06-05-2020

(06-05-2020, 05:49 AM)190531085100 Wrote: Something curious is happening to my NDRL - https://imgur.com/a/tynckVg - the screen goes blank in the middle, about 20 seconds after boot. This started to happen 2 week ago, even though I changed nothing, no firmware update, no cable or power changes. What could be going on?

When I push a button, the screen comes back. It does not come back on push of one of the chord buttons. If I remember correctly, it happened only occasionally in the beginning, but now it's on every power cycle. Firmware is 1.1.064. Planning to upgrade soon, I'm just wondering if I should be worried about anything else.
Weird, I haven't seen this one before, so I'll see what Steve and Darryl think and get back to you. 
Jesse


RE: Blank spot in screen shortly after boot up - Jesse Johannesen - 06-05-2020

(06-05-2020, 06:47 AM)Jesse Johannesen Wrote:
(06-05-2020, 05:49 AM)190531085100 Wrote: Something curious is happening to my NDRL - https://imgur.com/a/tynckVg - the screen goes blank in the middle, about 20 seconds after boot. This started to happen 2 week ago, even though I changed nothing, no firmware update, no cable or power changes. What could be going on?

When I push a button, the screen comes back. It does not come back on push of one of the chord buttons. If I remember correctly, it happened only occasionally in the beginning, but now it's on every power cycle. Firmware is 1.1.064. Planning to upgrade soon, I'm just wondering if I should be worried about anything else.
Weird, I haven't seen this one before, so I'll see what Steve and Darryl think and get back to you. 
Jesse
I talked to Darryl and he said that from time to time a global save may get corrupted and cause unusual behavior like this. He recommends a firmware update and a factory reset.
The most recent firmware (1.1.066) can be be found here:

https://conductivelabs.com/forum/showthread.php?tid=235

and instructions for updating the FW can be found here:

https://conductivelabs.com/download/

Factory reset can be achieved in the global settings menu which can be reached by holding [SHIFT + MENU] while powering up the device. Factory reset can be done by pressing the pad button.

Let me know if that solves the problem,
Jesse