+- Conductive Labs Support Forum (https://conductivelabs.com/forum)
+-- Forum: MRCC - MIDI Router Control Center (https://conductivelabs.com/forum/forumdisplay.php?fid=13)
+--- Forum: Hardware MIDI Connectivity (https://conductivelabs.com/forum/forumdisplay.php?fid=22)
+--- Thread: Can't get USB PC to USB host to work (/showthread.php?tid=1852)
Can't get USB PC to USB host to work - Raphie - 01-23-2022
I'm trying to migrate from MioXL to MRCC.
Currently setting up my DAW mapping
PC IN to DIN OUT works fine
Using PC virtual port 1 (named MRCC in DAW)
I push the PC left button (green)
Select virtual port 1 (highlights green)
Select the MIDI OUTS
send data over the right channels and everything works
PC IN to USB B out, doesn't work
Now, I connect a Moog One via USB to USB B > USB light > GREEN
Again I select PC Left button
This time I choose virtual port 2 (or MIDIOUT2 (MRCC) )
I select the right USB B button (turns blue)
I play on the right midi channel in DAW pianorol
nothing arrives at Moog One
Moog works fine when connected to MioXL via USB
Any suggestions? where am I going wrong?
RE: Can't get USB PC to USB host to work - Raphie - 01-23-2022
Found it, Moog One is not compatible https://conductivelabs.com/mrcc-usb-host-compatibility-tracker/
Damn, I wanted to decommission my MioXL, but no can do yet.
RE: Can't get USB PC to USB host to work - Dark Waves - 01-23-2022
Can you put your Moog on DIN cables? For purposes of MIDI, there shouldn't be any speed disadvantage. I've had to do that for some synths with non-compatible USB ports.
RE: Can't get USB PC to USB host to work - Raphie - 01-23-2022
The dins are all occupied, good reason to buy a 2nd unit
RE: Can't get USB PC to USB host to work - Dark Waves - 01-23-2022
If you mean two MRCCs, yes, that's very handy, it makes cabling across a middle space much simpler. If you meant two Moog Ones, well, I wouldn't mind that either.