Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Remote port labels
#1
How do I assign a label to a remote port? I have the remote 7 box and I can setup routings. Each routing has a port name like r2 but the label is none. I can’t figure out how to set this label.
Reply
#2
I'll take a look and see if I can figure that out. Hold tight!
Jesse

I'm looking at this and I'm not 100% sure that there is a way to do this implemented at this point. If I try to scroll to a destination past the last PC port it just loops back to the beginning. When Steve's back I can ask him, but it may be that he just chose to not have that option because the label data isn't passed via the connection and labeling it could create a situation where the label data is inaccurate between setups. I'll report back if I get anything useful.
Jesse
Reply
#3
The mrcc never leaves my studio and the cabling doesn’t change much. Almost 1/3 of my synths are connected to the remote box and these cannot be labeled. This seems like an unexpected user experience.
Reply
#4
FWIW, this is important to me too. I also very rarely change cabling so would be very nice to label remote ports.
Reply
#5
Yes, this is quite a frustrating limitation. Are there plans to fix?
Reply
#6
I would also love to see labeling for devices connected via the Remote7.
Reply
#7
+1 for me too
Reply
#8
Our team is taking a look to see how difficult this would be to implement, we appreciate the feedback and will let you know if we make any progress in this direction.
Reply
#9
any news about this? my remote is hidden behind a desk, so its always a bit awkward to have to look which cable goes where. now i put a sticky note next to the mrcc, but it would be great to have this inside the box.
Reply
#10
No, I haven't seen anything from Steve on this yet. I will post here if he makes any progress.
Reply


Forum Jump:


Users browsing this thread:
1 Guest(s)