Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Chord seq. starting step issue
#1
Hi there, sorry if this was already mentioned but I could not find it in previous threads. My issue with the chord sequencer is when I press stop on the NDLR and then restart the NDLR with the sequencer armed, the chord sequencer almost never restarts at step one, making it out of sync with my other gear (i.e. Digitakt in this case with the NDLR setup as clock out and transport out). Is there a way to make the chord sequencer always restart at the beginning of step 1?
Reply
#2
At this point the way to reset the Chord Seq is to disable it and enable it again. If I haven't added a feature request for this yet, I will. You are definitely not the first to ask.
Jesse
Reply


Forum Jump:


Users browsing this thread:
1 Guest(s)