Greetings,
I've noticed that Pad notes occasionally get stuck while changing chords. In troubleshooting this the Pad range was reduced down to 1 note but oddly the NDLR sends two different Note On messages (which seems like a bug?). After a chord change it sends a single Note Off message, leaving one note hanging.
The Panic function doesn't kill it. Have to power cycle the sound module or temporarily switch to a different patch. This appears to occur frequently and is fairly repeatable. Am running the latest FW release. Like Spread thinks there's more than 1 available note to play...
Had also experienced some other strange behavior with Pad, where by Poly-Chain was set back to 1 but the display would display Pad (+3). Power cycling doesn't clear this out either. The only thing that I hadn't done was reset it back to factory default settings...
My apology is this was already posted, hadn't checked recently.
I've noticed that Pad notes occasionally get stuck while changing chords. In troubleshooting this the Pad range was reduced down to 1 note but oddly the NDLR sends two different Note On messages (which seems like a bug?). After a chord change it sends a single Note Off message, leaving one note hanging.
The Panic function doesn't kill it. Have to power cycle the sound module or temporarily switch to a different patch. This appears to occur frequently and is fairly repeatable. Am running the latest FW release. Like Spread thinks there's more than 1 available note to play...
Had also experienced some other strange behavior with Pad, where by Poly-Chain was set back to 1 but the display would display Pad (+3). Power cycling doesn't clear this out either. The only thing that I hadn't done was reset it back to factory default settings...
My apology is this was already posted, hadn't checked recently.