Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Start/stop don't pass MIDI-Through
#1
Hi Community,

I just purchased a NDLR a few days ago.


My problem is that the master clock start/stop messages from my other sequencer (Toraiz Squid) doesn't go though the NDLR.

The Synths that I trigger with the NDLR don't get the SSC any more. I tried all menu-settings for the clock-out-port, without success.

MIDI-notes are passed through correctly, only SSC messages aren't.

My Squid is connected to MIDI B Input, my synths are connected to MIDI B Output.

The Squid is not using the same channel as the NDLR Cntl channel. (I don't use/need the Cntl channel at all.)

(I haven't tried yet to use the same channel as KB Trans.  - because I don't want the KB to transpose...

As the masterclock comes from my Squid, the NDLR is set to external clock. There IS a clock coming in, the NDLR shows that with the blinking letters on the display.)
Reply


Messages In This Thread
Start/stop don't pass MIDI-Through - by Kai-vD - 01-07-2020, 11:40 PM
RE: Start/stop don't pass MIDI-Through - by DanS - 01-19-2020, 04:02 PM
RE: Start/stop don't pass MIDI-Through - by DanS - 01-29-2020, 01:06 PM
RE: Start/stop don't pass MIDI-Through - by Steve - 02-05-2020, 10:42 PM
RE: Start/stop don't pass MIDI-Through - by DanS - 02-09-2020, 11:30 PM

Forum Jump:


Users browsing this thread:
1 Guest(s)