Thread Rating:
  • 2 Vote(s) - 3 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Encoder sensitivity
#4
(02-01-2019, 08:13 AM)funktree Wrote:
(01-16-2019, 12:21 PM)Darryl Wrote: We have played with various sensitivity adjustments and I think where we ended up is tuning each parameter individually. We chose an incremental encoder with a high resolution so you would not have to turn multiple revolutions to get from end to end, but we probably could have used a lower res encoder as most parameters only go to MIDI lengths. I am sure we will revisit the sensitivity on the most touchy ones.

How about acceleration:
 slow turning => less changes 
faster turning => more change 
... I found the key parameters very sensitive:
- Clock division
- Pattern selection 
- Mod Destination

Good list for us to start with. The acceleration idea is also good, I think we considered that but it didn't make the cut.
Reply


Messages In This Thread
Encoder sensitivity - by drGrov - 01-12-2019, 03:41 AM
RE: Encoder sensitivity - by Darryl - 01-16-2019, 12:21 PM
RE: Encoder sensitivity - by funktree - 02-01-2019, 08:13 AM
RE: Encoder sensitivity - by Darryl - 02-02-2019, 07:23 PM

Forum Jump:


Users browsing this thread:
1 Guest(s)