04-16-2022, 04:36 AM
(This post was last modified: 04-16-2022, 07:28 AM by oldgearguy.)
This morning I am trying to send a sysex message from a controller connected via DIN and MRCC-A to a device connected on USB-A on MRCC-B
When I monitor the traffic, I see it going from the controller to MRCC-A, but it never seems to appear over on MRCC-B.
In parallel, I have something generating MIDI notes going from MRCC-A to MRCC-B and the receiving device plays just fine.
Is there anything in the code/configuration that would prevent sysex going across MRCC connections?
If I press the "Y" button, I see the in/out LEDs are properly lit.
It could be some user config error here for sure, but wanted to know if you guys checked sysex between MRCCs.
Thanks
When I monitor the traffic, I see it going from the controller to MRCC-A, but it never seems to appear over on MRCC-B.
In parallel, I have something generating MIDI notes going from MRCC-A to MRCC-B and the receiving device plays just fine.
Is there anything in the code/configuration that would prevent sysex going across MRCC connections?
If I press the "Y" button, I see the in/out LEDs are properly lit.
It could be some user config error here for sure, but wanted to know if you guys checked sysex between MRCCs.
Thanks