Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Pressing the pad encoders does not bring up the pad sub screen
#1
Hello all,

Here is the issue I am experiencing:

The expected behavior when I click on an encoder, is that the sub screen that corresponds to that encoder should pop up. This is what happens with the motif, drone and tempo/key/mode sub screens. I click in any of the encoders for the motif sub screen and the motif sub screen comes up. Same with the drone sub screen (click on the encoder and the sub screen pops up) and same with the tempo/key/mode. However, if I click on any of the pad encoders the pad sub screen does NOT come up. The sub screen stays in the previous sub screen. Only when I turn the pad encoder that I clicked, then the screen changes to the pad screen at the same time that the parameter value changes.

Anybody else experiencing this issue?

PS: If it would be helpful I can try to post a video

My unit has FW 1.1.066

Cheers

J
Reply


Messages In This Thread
Pressing the pad encoders does not bring up the pad sub screen - by JoseC - 07-12-2020, 10:20 PM

Forum Jump:


Users browsing this thread:
1 Guest(s)