+- Conductive Labs Support Forum (https://conductivelabs.com/forum)
+-- Forum: MRCC - MIDI Router Control Center (https://conductivelabs.com/forum/forumdisplay.php?fid=13)
+--- Forum: General Support (https://conductivelabs.com/forum/forumdisplay.php?fid=14)
+--- Thread: Modifier slot is freezed (/showthread.php?tid=3625)
Modifier slot is freezed - johnleborgne - 05-01-2025
Hello,
When making some tests about the transpose issue, I came accross a weird but reproductible problem : modifier stop responding to input, it seems freezed.
There is a simple pattern, easily reproductible.
One source, tree ouputs. (or 4 outputs)
For the first ouput, set a modifiers, I had a T1 modifier.
Nothing need for ouput 2 and 3
When you look the MRCC output, output 1 is the left most, the other two came after to the right (this is important, order matters)
Now, just remove output 1 from the routing.
Try to set a modifiers in the output 2 (which was notmally auto selected), it works.
try the same from ouput 3, it won't work anymore.
=> you have to reselect the output 1 to re-enable the modifiers in ouput 3.
If you try this with 4 ouputs routing, the problem will occur on the 3d one again.
I made a video if needed.
Best
John
RE: Modifier slot is freezed - Jesse Johannesen - 05-04-2025
Thanks John, can you send me the video? Support@ConductiveLabs.com
Jesse