+- Conductive Labs Support Forum (https://conductivelabs.com/forum)
+-- Forum: MRCC - MIDI Router Control Center (https://conductivelabs.com/forum/forumdisplay.php?fid=13)
+--- Forum: General Support (https://conductivelabs.com/forum/forumdisplay.php?fid=14)
+--- Thread: Standby bug (/showthread.php?tid=1778)
Standby bug - jbdiver - 10-28-2021
Access the assign label tool, select a port like output 10, press the green button to enter standby mode. The output 10 led stays lit which I do not think is expected.
Also, I managed to lock up the mrcc by switching standby on and off a few times. I haven’t been able to reproduce this system lock up consistently.
RE: Standby bug - Jesse Johannesen - 10-31-2021
I was able to reproduce this error and I've added it to the Bug Sightings list. Good eye!
Jesse