+- Conductive Labs Support Forum (https://conductivelabs.com/forum)
+-- Forum: MRCC - MIDI Router Control Center (https://conductivelabs.com/forum/forumdisplay.php?fid=13)
+--- Forum: General Support (https://conductivelabs.com/forum/forumdisplay.php?fid=14)
+--- Thread: Screensaver Mode (/showthread.php?tid=1716)
Screensaver Mode - MickG - 08-25-2021
In the MRCC video: "Conductive Labs MRCC Live Stream for Synthesthesia 2021", the guys talk about Screensaver Mode (1:12:30).
They say that the USB ports will be disabled if this mode is enabled, but they also say that the MRCC can be configured so that the USB ports remain active in Screensaver Mode. However, they don't say how to set up this configuration.
Can you enlighten us please?
Is it "USB Hub Sleep" in SETTINGS Page 2?
RE: Screensaver Mode - Jesse Johannesen - 09-05-2021
(08-25-2021, 11:54 AM)MickG Wrote: In the MRCC video: "Conductive Labs MRCC Live Stream for Synthesthesia 2021", the guys talk about Screensaver Mode (1:12:30).Yes, USB Hub Sleep is the correct setting. If set to N the USB host ports stay powered when MRCC is put into sleep mode. They do not stay active in the sense that they monitor data however to the best of my knowledge.
They say that the USB ports will be disabled if this mode is enabled, but they also say that the MRCC can be configured so that the USB ports remain active in Screensaver Mode. However, they don't say how to set up this configuration.
Can you enlighten us please?
Is it "USB Hub Sleep" in SETTINGS Page 2?
Jesse
RE: Screensaver Mode - MickG - 09-25-2021
Cool - thanks
RE: Screensaver Mode - xeamus - 10-12-2022
When will we have a screensaver for MRCC? It´s a must to not burn the screen if I forget to turn it off when I´m away, say for holiday a couple of weeks.
RE: Screensaver Mode - Jesse Johannesen - 12-03-2022
We just added a screen saver, I have a test FW in review now, it should be up for general consumption in the next week.
RE: Screensaver Mode - Darryl - 12-20-2022
(12-03-2022, 08:15 PM)Jesse Johannesen Wrote: We just added a screen saver, I have a test FW in review now, it should be up for general consumption in the next week.
The 1.1.068 beta firmware with the screen saver and several other improvements is now posted in the MRCC Open Beta Firmware forum for anyone to try.